Pipercross Ref: MPX077R OEM Ref: 11013-1301 K&N Ref: KA-6003

Moulded Panel

Pipercross motorcycle air filters are designed specifically for each application and give a noticeable increase in performance, improving both engine power and torque.

Fitting straight into the standard airbox, the Pipercross road filter protects your investment so you can concentrate on enjoying it!

 

For Air Filters Marked TRACK USE ONLY - Unique to Pipercross, The race specification air filter foam is designed to maximise airflow and performance. Only for use on the race circuit, the race spec filter requires fuelling modifications to take advantage of the increased airflow and to prevent engine damage.

 

Pipercross Cleaning Instructions

 

The cleaning of a Pipercross air filter should be carried out as below. Failure to do this could result in damage to the air filter or even the vehicle.

• Remove excess dirt by gently brushing the filter.

• Apply cleaning additive (C9003 or C9000) liberally. Massage in with soft brush. Allow to soak for around 5 minutes.

• Flush the filter out with warm water from the clean side of the foam to the dirty side.

• Allow the filter to dry naturally (do not apply any heat to the filter!!)

• Lightly apply dirt retention additive (C9007 or C9001) on the dirty (black) side of the foam.

Steps 2-4 may need to be repeated until the filter is clean. Do not over oil the foam as this will cause a lack of performance.

 

Pipercross Air Filters